C7 Corvette Rear Quarter window flag decal. 2014-2019 Corvette. for Sale

Price: $35

This item has been shown 3237 times.

C7 Corvette Rear Quarter window flag decal.



Newly added is the 3M Camo Distresed flags. High quality 3M 1080 wrap decal. This decal changes different colors with outdoor lighting from the sun, as you look at the different angles you'll see

Want that unique look on your Vette? You'll be riding with more style with these C7 Corvette Rear Quarter window flag decals

They come with both driver and passenger sides.These can be installed yourself or a Vinyl/tint shop that installs decals on vehicles. We recommend a professional shop to install these.Contact us for a specific design you'd like and email us a picture of it and we can add it for you. Instagram name, YouTube channel, ect. we also carry all the military branches.
The Red White and blue flag is a 3 piece vinyl design that is custom made using 3 pieces of vinyl

  • Oracle 651 vinyl.
  • AutoSpeed 5D Carbon fiber vinyl wrap.
  • 3M for Camo distressed flags ( This cost more money but it's 3M 1080 series vinyl and one of the best on the market)
  • Fits 2014-2019.
  • These are created from our C7 Performance graphics designer. Copying of these images and designs to recreate the same purpose areunauthorized.

*Note:Decal kits should be installed by an experienced installer.
This is NOT a "Do It Yourself" project for most people.

  • Do not install in direct sunlight.
  • Be sure the installation area and surface temperature is between 10°C (50°F) and 20°C (68°F).
  • Know that the wet method is NOT recommended for interior installations and donot store vinyl decals in direct sunlight.

    Things you need…

    • Installation squeegee
    • Application fluid in a spray bottle (Mixture of 500mL (1/2 quart) of water, 250mL (1/4 quart) of 99% rubbing alcohol and 1 teaspoon of liquid soap) –
    • Non-AMMONIA BASED window washing liquid
    • Paper towels
    • Measuring tape or ruler.
    Preparation:

    Carefully remove all dirt, grease and/or wax from application surface. Be sure to remove thecar wax, Turtle wax, Rain-x, compound, etc. The decals will NOT adhere properly to un-cleaned surfaces. Be careful to not use ammonia-based cleaners. This could create bubbles under your vinyl decal.

    So once the surface is ready, follow below steps…

    Step 1:Use the squeegee, pressed onto a hard surface. Press firmly over the decal to assure pre-mask is properly attached. Turn the decal over (pre-mask down) and slowly peel off the “liner” exposing adhesive. Do not allow the sticky part of the vinyl decal to touch anything. Generously spray application fluid over the surface area where thevinyldecal will be installed. Be sure the surface area is completely sprayed down and there are generously spray application fluid onto the adhesive side of the decal.

    Step 2:Place the adhesive side on the surface.While wet, carefully measure and adjust the vinyl decal. Once it is placed, use a squeegee with firm strokes to force application fluid out to assure firm placement. Repeat until you remove most of the application fluid between decal and surface. Ensure there are no fluid or air bubbles.

    Step 3:Wait between 30 minutes to an hour or more to allow complete drying and secure adherence. Temperature can affect drying time

    Step 4:Once dry, peel off the “pre-mask” from decal and surface.If peeling occurs, re-apply decal with a squeegee (Step 2), and wait about 30 minutes before you remove the “pre-mask” again.



    Parts Search:


    Follow