Price: $87
This item has been shown 33745 times.
DESCRIPTION:
that may arise.
Gives you and your family safer nighttime driving.
Makes your car looks newer.
See road markings and traffic sighs better.
Driving at night can be a scary proposition - and it's even scarier if you can't see the road well.
A dim, cloudy, yellowed, or otherwise damaged or non-functioning headlight makes driving dangerous,not only is your own
safety at risk, but the safety of others is as well.
COMPATIBLE WITH:
For 2004 2005 2006 2007 2008 2009 2010 2011 2012 Chevrolet Colorado
For2004 2005 2006 2007 2008 2009 2010 2011 2012 GMC Canyon
For2006 Isuzu i-280/i-350
For2007 2008 Isuzu i-290/i-370
SPECIFICATION:
High Beam: HB3/9005 (NOT included)
Low Beam: HB4/9006 (NOT included)
Turn Signal Light: 3157
FEATURES:
Chrome Housing Clear Lens Amber Reflector With Bumper Lights
SAE/DOT approved for street legal
High grade ABS plastic: for toughness, impact resistance, and heat resistance.
Plug-n-play installation: fully compatible as replacement for factory parts.
High Quality: Fully sealed, waterproof, dust and corrosion resistant, works perfectly even in harsh weather conditions.
Bulbs are NOT included, need to reuse original bulbs.
PACKAGE INCLUDES:
4pcs, LH (Driver Side) & RH (Passenger Side) Headlights + Bumper Lights
NOTE:
Before you begin to adjust the light, make sure check the alignment of your lights first. Park the vehicle about 10 to 25 feet
fromthe wall with the lights aimed at the wall. The center lines of the headlights should not be any higher than 3.5 feet above
the ground.
1.Find the adjustment screws.Firstly, locate the adjustment screws on your vehicle.
2.Adjust the headlights individually.The headlights should be adjusted one at a time. Put a rag or towel over a chair in front
of the light you want to block. Covering the light assembly directly can damage the plastic lens.
3.Adjust the vertical field.The screw on the top of the light housing should be turned clockwise to raise the lights and
counterclockwise will lower the light. The headlight should be adjusted until the top of the most intense part of the light
beam shines directly on or just below the center of the tape line on the wall.
4.Adjust the horizontal field.The screw on the side of the light housing should be turned to get the right/left adjustment
correct. Adjust the lens so that the most intense part of the beam is to the right of the vertical line.
5.Test your results.